Joined in 2023 
82 
63 About this deal
A mixed wired and wireless system is often referred to as a hybrid system. To set a hybrid system up. Simply fit one Ei168RC base to an alarm in the existing alarms and any new alarms with Ei168RC bases. Features built-in tamper proof Rechargeable Vanadium Pentoxide lithium standby cells, capable of lasting at least 10 years and powering the module initially for at least 2 months in the event of mains power failure. The cell manufacturer endorses a minimum 10-year life expectation for the rechargeable cells, which are activated by operating the battery switch inside the module. The Ei168 base will normally be wired to the nearest mains circuit in the ceiling (usually the lighting circuit). The alarm is then slid onto the base rather than to its mounting plate. As many as twelve units can be interconnected in this way In code mode, the amber indicator will flash to indicate the number of other RF alarms that have been 'leaed' in the system
A RadioLINK Manual Call Point, Ei407 and remote control switches Ei450, Ei412 and Ei411H are also available for use in the system. See separate specification sheet(s) for further information.
We’re Here To Help
Alarm identification can sometimes be difficult as some alarms can look quite similar, but there are a few ways that you can tell them apart. We have also highlighted a few of the most popular products. Eliminates the need for any cabling between the Ei428 and the smoke, heat and CO alarms used in the system. If you are using an Alarm Controller Ei450 this will continue for as long as you hold down the ‘Test’ button. Once the system has been set up, information can be accessed securely from within or outside a property if access is an issue. Event logs can be retrieved as many times as necessary and for each alarm on the system, retrieving data such as how many direct button tests have been performed and when, any issues with the battery and/or mains supply, Carbon Monoxide (CO) levels detected if a CO alarm is on the system, Radio Frequency signal strength between alarms, age of alarms and any alarm removed.
The Ei168 RadioLINK Base transmits a Radio Frequency (RF) alarm signal when the unit attached to it senses fire. When it receives an RF alarm signal from another Ei168 Base, the attached smoke or heat alarm will sound. It therefore eliminates the need to run long interconnect wires between all the smoke alarms on different floors and in different rooms. Step 8 – The blue LEDs on all units will now stop flashing and the entire system will automatically ‘seal’. Above this is the ‘Replace By’ date, but note that the date on the label shows the maximum life of the alarm and alarms should always be replaced before their life is up. If you have more than one alarm in the property and they are interconnected, this will also trigger all the other alarms in the property.
100% SATISFACTION GUARANTEE - 14 Days to return the product for a refund if not entirely happy.
The product is CE marked to indicate conformance to BS EN 60065:1998 (Electrical Safety), EN300220-1 V1.3.1 (2000-09) (RF Performance), EN301489 V1.4.1 (2002 08) (EMC) and has been 3rd party tested for electrical safety in accordance with Annex K of BS 5446: Pt.1:2000. Designed for use with the Easi Fit range of alarms and its fully compatible with any Ei160 or Ei140;series alarms. - It is from here that the radio signals are transmitted and received. If RadioLINK+ is used, ensure the alarms have been House Coded together correctly. They may have been connected to a nearby system. Reset and House Code again. Step 1 – Ensure all your alarms have been installed and tested and you have inserted your Ei100MRF or Ei3000MRF modules into your 160e Series, Ei2110e alarms or Ei3000 Series.
Great Deal 
New Comment