Coleman Mach 9630A3361 Wall Mount Digital Thermostat-12 VDC, Single Stage, Black

Product Information

Pair up to 3 Thermostats to a single smart device Connect up to 4 smart devices to control thermostat operations For iOS and Android devices iOS 9. Below, we have provided a list of Coleman Mach thermostat part numbers to assist in selecting the correct Bluetooth Thermostat. and a few other items to drop the 24vac to 12vdc coming out of the Thermostat that sends the signal to the Furnace and or AC to kick on. Please do not use with any other application other than that which is specified in the installation and operating instructions.

These are just my thoughts and not necessarily correct but based on my experience installing a couple. A few years ago, in my 2008 Wildcat I tried to change from Dometic analog thermostat to a Coleman Mach digitial just like you have pictured. Simply set the temperature using the easy-to-use slide selection switch, and the thermistor air temperature sensor will activate heating or cooling as needed to maintain your ideal environment.granted, probably not the same 2 you're asking about, but maybe some of the "wiring" info might be helpful.

one set were people adding the control box to a Coleman-Mach t-stat in which case the t-stat had a connection for the blue wire. A/C -> blue wire to t-stat - this is labeled as 12 VDC(-), and then the diagram shows that there should be a 12VDC(-) connection to the t-stat. When I did some work at home here the thermostat instructions explicitly said the blue wire must be connected.The Coleman Mach Thermostat is a single stage heating and cooling wall thermostat with a digital display. To calculate the overall star rating and percentage breakdown by star, we don’t use a simple average. I am in the process of installing one of the Airxel Circuit Boards that will allow me to connect my A/C to be thermostat controlled. After finding a loose wire,I really thought I would not need it but the Hunter went south again today.

ZC zone control thermostat, you can control up to four rooftop air conditioners or heat pumps, plus four zones of gas, hydronic or electric strip heaters and fans all in one location! I had my Lux battery operated digital programmable t-stat laying around from when I switched over to Geothermal and installed it the other day. International products have separate terms, are sold from abroad and may differ from local products, including fit, age ratings, and language of product, labeling or instructions. On the top of ScottG's photo above, it looks like the labels are silk screened in white behind the wires. Coleman-Mach Makes A Diverse Selection Of Wall Thermostats To Help Keep You Warm Or Cool You Off While You’re On The Road.

I could easily connect the new control panel straight to the VDC(-) at the same connection point at the heater and bypass the t-stat. The problem ended up being a connection that had come loose on a wago style connector behind the electrical control board, I finally found out where all the wiring went ! So, I guess I would then ponder, does it do any good or harm to connect the blue wire that leads to the A/C to the VDC(-) that is not connected to the t-stat. The other set seemed to be folks going with an aftermarket t-stat, and just tucking the blue wire in the wall. For example, if you have an 8xxx series control package, you cannot use that control kit with this 9xxx series thermostat.

It would not work because the voltage from the ac relay board to the thermostat power in (red wire) was stepped down to 7.Note: This thermostat is generally specific to the appliance it is being used with and is not universal. If your new thermostats requires 12 volts but does not use batteries then you will need the blue (-) wire. So at this point I am throwing in the towel and looking for a mobile tech when I get to the east coast.