Indesit Washing Machine Drain Pump Filter Kit

Product Information

Follow our five easy steps and watch the video on How to clean a smelly washing machine. Washing machine has a burning smell Once the bottom panel in the front is removed, you get access to the pump filter. Now, put the towel on the floor to filter the location. And remove the water from the emergency hose located close to the coin trap and use a bowl to store the water. Before doing laundry, run a test wash cycle to ensure everything works correctly. It’s an excellent time to clean the inside using some washing machine cleaning detergent. Run it on a clean cycle setting with a high temperature of up to 90°C. FAQs

If it's clear, then you might need to give the machine a good clean. Mould, built-up grime and detergent can all contribute to bad smells. Contaminated Seal on Filter: Each filter in Indesit Washing Machine traps dirt and particles and filters the clean wastewater. Its pump filter has a seal on it that tightly fits the filter inside the housing and seals the gap.

Great product, easy to fit

Indest washing machines look similar in design to other brands’ washers, but there is a difference in filter location. Many of our newer Indesit washing machines have a series of indicator lights, which flash to indicate a possible fault. The most common are: A: The wash cycle length depends on the program selected and the load size. Most wash cycles range from 30 minutes to over an hour. Most modern washing machines will display an error code on the control panel if there's a problem with the heating system. You can then search for this error code along with the make and model of your machine to find a fix.

As part of the manufacturing process we thoroughly test your washing machine to ensure that it will not leak from any internal components after you have installed it.If the drain pump filter kit in your washing machine becomes clogged with lint, hair, or other debris, it can hinder water flow and cause drainage issues and need replacement. This drain pump filter kit by Hotpoint is a genuine washing machine replacement part. It also suits Ariston, Indesit, Nordmende, Scholtes, and Whirlpool washing machines. Manufacturers Part Number: The good news is that you can easily replace it yourself or hire a tradesperson to do it for you – just make sure you buy a timer that is compatible with your washer make and model. Replacing the control board can be an expensive repair so you should consider the cost of the repair against a new washing machine. If your washing machine is showing the F13 error code and is struggling to drain the water, you should look inside the drain pump filter.

Most front-loading washing machines are designed at the standard dimensions of 85cm high and 59.5 to 60cm wide. And most kitchen cabinets are also designed to accommodate this size.There is a small emergency pipe located closer to the pump filter, using that hose to make the drum water-free. Follow the next section to properly install the Indesit Washing Machine filter. If the bolts have been removed and it's still not working it might be an issue with the installation. Make sure the power source is entirely off before doing anything. Unplug it from the mains supply to be sure it doesn’t come on by accident. Open the filter cover Faulty heating – If the machine turns off in the first half hour, the water may not be heating up correctly, which will signal for the machine to stop mid-cycle. On the other hand, if the cycle stops past 30 minutes the water may be overheating, again forcing the cycle to come to a halt. The most likely cause for this is a faulty thermistor.