SOK Battery 100Ah 12V LiFePO4 Lithium Iron Phosphate Deep Cycle Battery,Perfect for Your RV or Any Off-Grid Applications,Low Temperature Disconnected.

Product Information

In a stationary application, the SOK 48v battery can be installed in any orientation with the exception of upside down, as viewed from the front panel. This means installation on-end, sideways or even face down would be perfectly acceptable. Battery Orientation – Mobile Application

Enjoy peace of mind with the SOK battery’s comprehensive protection against overcharging, discharging, and short circuits, safeguarding both the battery and connected devices. The battery cells auto-balance, ensuring consistent performance and longevity. High and Low Temperature Disconnects The float voltage is not actually a charging voltage; it is a voltage that can be provided by a charger that matches the resting full-charge voltage of the battery. Some chargers allow float to be disabled, however we do not recommend doing so. By leaving float enabled and set at the recommended voltage, the charger (whether solar or grid) will provide the power to loads FIRST, and the battery will make up for any additional current demanded by the loads.

Do you offer free shipping?

is the most optimal absorption voltage, however if the charger doesn’t let you program this voltage, anywhere from 57.6 up to 58.4v is still safe and within normal operating parameters for these batteries. Absorption Time

Hold your pre-charge resistor with one side making connection to the main negative cable you removed in step 2, and the other side touching the negative terminal the cable would normally connect to Note: when batteries are operating in closed-loop communication mode, there is no “float” mode – when loads require power they receive it from the source, and if discharging of the battery occurs, then the battery recharges to 100% and the charging process ends until recharging is required. Charging SOC% They do not support closed-loop communication, however, you can use voltage-based control by setting your absorption voltage at 57.6v, float voltage at 55.2v and low-voltage shutdown at 48v. It would work just fine for your application! Ensure the BMS(s) in all batteries have been de-activated – this means none of the LED lights on the front panel are illuminated. As for most electronics, extreme humidity & condensation is not good for long term performance or integrity. Avoid environments that have condensing humidity and be especially cautious in locations near the ocean where salt spray may be present, as this can cause accelerated degradation that wouldn’t be covered by warranty. If a high humidity application is expected, install the batteries in a sealed / outdoor rated enclosure. Proximity to Equipment

Experience reliable and long-lasting power with the SOK 12V 100Ah Lithium-Iron Phosphate (LiFePO4) Deep Cycle Battery. It’s designed to exceed expectations and deliver unparalleled performance for all your power needs. Whether you’re embracing the freedom of van life, enjoying the comforts of an RV, or powering your off-grid cabin, this battery is your dependable energy companion. Don’t settle for less when you can have exceptional value with an SOK Battery! Capacity and Voltage Floating in this manner will prevent discharging the battery while ample charge is available – whether coming from Solar, Grid or Generator. If floating was disabled or set to a lower voltage, then the battery could be significantly discharged when the user thinks that it’s been connected to a charger and should be full and ready to go. This is contrary to the float-charge of a lead acid battery, as a lead acid battery will self-discharge when sitting and must be continually be fed charge current to keep it topped off. The SOK 100ah Lithium Deep Cycle battery has been on the market for over a year and is one of the best selling batteries for good reason. This battery will do what you need it to, and it lasts a really long time - 4000-8000 cycles! Great for Vanlife, RV's, Off-grid cabins or anything that needs reliable power.

Ensure all batteries are in the “BMS-OFF” state prior to installing the cable(s) as explained in the shutdown procedure. After the cable(s) have been installed, power up the system per the proper pre-charge procedure. If the battery is not detected by the Cerbo: State of Charge: 30% (NOTE: Set this to 30% with brand new, untouched batteries. They ship at 30% SOC%.) The default screen shown when BMS is powered on. The only option on this screen is to press the “Menu” button to view the main menu. Main Menu The communication cable plugs into the CAN-BMS port of the Cerbo-GX, and a terminator provided with the Cerbo-GX must be plugged into the empty port. Extended Cycle Life: The SK48V100 offers impressive longevity and reliability with high-capacity cells that retain 80% capacity after 4000 cycles. That is even at a 100% Depth of Discharge (DOD) with a 1C rate.The SK48v100 has been tested by Intertek Laboratories and has been certified to conform to UL 1973 standards. Expect exceptional durability from the SOK battery, as it offers an impressive 4000-8000 cycle life span. It is equipped with a built-in Smart BMS, providing intelligent monitoring and protection to optimize performance and prolong battery life. Low Temperature Charging Protection and Grade A Cells A replacement Physical Good or part assumes the remaining warranty of the original Physical Good or 1 Years from the date of replacement or repair, whichever is longer. Not every charger allows you to dial in the exact voltage you need. Some only allow for coarse adjustment via DIP switches, as an example. I have tested a lot of batteries, and this one blows away the competition. If you want a budget battery that will not give you any problems, this is the way to go!