About this deal
Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware or to follow Cisco AutoConfig determines the level of network access provided to an endpoint based on the type of device. This feature also permits hard binding between the end device and the interface. IEEE 802.1X user distribution, which enables you to load-balance users with the same group name across multiple different VLANs. For the best support of the switch and cables, make sure that you attach the switch securely to a wall stud or to a firmly
If you insert a 10G SFP+ in to a 1G SFP module slot and vice versa, you need to clear the existing configuration by running mm) holes at each of the two mounting locations. Insert the supplied 0.5 in. (12.7 mm) number-8 Phillips wood screws Multidomain authentication to allow an IP phone and a PC to authenticate on the same switch port while being placed on the appropriate voice and data VLANs. The ports provide PoE support for devices compliant with IEEE 802.3af and 802.3at (PoE+), and also provide Cisco prestandard MB, 1 GB, 4 GB, and 8 GB are supported). Cisco IOS software provides standard file system access to the flash device:Removing and installing an SFP module can shorten its useful life. Do not remove and insert any module more often than is
The 10/100/1000 ports use RJ-45 connectors with Ethernet pinouts. The 10BASE-T, 100BASE-TX, 1000BASE-T traffic requires Category5 The switch 10/100/1000 Ethernet port configuration changes to operate at the speed of the attached device. If the attached number unless they are manually changed, or the number is used by another member in the same group. If a number changes, the the default-interface
IP Source Guard to restrict IP traffic on nonrouted Layer 2 interfaces by filtering traffic based on the Dynamic Host Configuration Protocol (DHCP) snooping binding database or by manually configuring IP source bindings. Do not remove the dust plugs from the modules or the rubber caps from the fiber-optic cable until you are ready to connect Cooling mechanisms, such as fans and blowers in the switch, can draw dust and other particles causing contaminant build-upRJ-45 ports and SFP-module slots have port LEDs. These LEDs, as a group or individually, provide information about the switch
If you manually change the number of a member, and no interface-level configuration is associated with that new number, that This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment,
Note: Bystander positions operating mode at 77°F (25°C) ambient; All other models are fanless for silent operations