Victron Energy SmartShunt 500 amp Battery Monitor (Bluetooth)

Product Information

This parameter is used to tell the battery monitor how big the battery is. This setting should already have been done during the initial installation. The setting is the battery capacity in Amp hours (Ah). By connect I mean I can launch VictronConnect and see from the Device List the basic live reporting information sent from the shunt. So far so good. It's doing what I hoped it would do. zero) disables the filter and gives an instantaneous (real-time) readout. However, the displayed “Time remaining” value may fluctuate heavily. Selecting the longest time, 12 minutes, will ensure that only long-term load fluctuations are included in the “Time remaining” calculations. Battery SOC on reset Set the Peukert exponent according the battery specification sheet. If the Peukert exponent is unknown, set it at 1.25 for lead-acid batteries and set it at 1.05 for lithium batteries. A value of 1.00 disables the Peukert compensation. The Peukert value for lead- acid batteries can be calculated. Charge efficiency factor (%) Stiffness analysis of 3D spheroids using microtweezers. PLoS One. 2017; 12( 11):e0188346. [ PMC free article] [ PubMed] [ Google Scholar]

The treatment of infantile hydrocephalus:” differential-pressure” or” flow-control” valves. Childs Nerv Syst. 2000; 16( 4):242–6. [ PubMed] [ Google Scholar]This setting is relatively simple, if you have a single battery it’s really easy (the stated capacity of your battery in Ah) If your battery capacity is stated in Kwh then divide by the voltage of your battery.

When the current measured falls below the “Current threshold” value it will be considered zero. The “Current threshold” is used to cancel out very small currents that can negatively affect the long-term state of charge readout in noisy environments. For example, if the actual long-term current is 0.0A and, due to injected noise or small offsets, the battery monitor measures 0.05A the batery monitor might, in the long term, incorrectly indicate that the battery is empty or will need to be recharged. When the current threshold in this example is set to 0.1A, the battery monitor calculates with 0.0A so that errors are eliminated. To understand which size inverter you require, you will need to work out the wattage to match your requirements. To do this, you will need to add up the wattage of each 230V appliance you want to use, and find out their rated power draw. Usually the item manual will provide the wattage draw.

If the battery monitor is connected to a GX device, such as the Cerbo GX or the ColorControl GX, the battery can be monitored locally with the GX device or remotely via the VRM portal.

Please note that if the "Consumed Ah" reading indicates three dashes: “---” this means that the battery monitor is in an unsynchronised state. This mainly occurs when the battery monitor has just been installed or after the battery monitor has been left unpowered and is powered up again. For more information, see the Synchronising the battery monitor chapter.A few days ago I bought and installed an IP65 SmartShunt to monitor my travel trailer's two house batteries. From the app I can connect to the shunt from about 30 feet away. Before we even get to the SmartShunt settings you’ll want to make sure your BMS and charger are similar. In our case, we set our JK BMS with active balancing to 3.55v high-volt-disconnect (per cell meaning a total of 14.2v for the battery). This is also the default for a Victron Multiplus when LiFePO4 is chosen. Please note that if the state of charge indicates three dashes: “---” this means that the battery monitor is in an unsynchronised state. This mainly occurs when the battery monitor has just been installed or after the battery monitor has been left unpowered and is powered up again. For more information, see the Synchronising the battery monitor chapter.