A word of warning: As it reacts to the mineral deposits, the acid will neutralize and release toxic gasses right into your face. You want to be using this product in a well-ventilated area with full protection equipment - gloves, eyewear, and a respirator. Occasionally you may need to return an item which you have received, if you are not satisfied with your item you can return the item to uswithin 14 daysof receipt. Adam’s Polishes] wheel cleaner is good enough to react with the iron particles on the caliper and loosen them to the point it can be sprayed right off, with little to no agitation only if you use a pressure washer with a 40-or-less degree nozzle.” –Bilal F. Those running wheels with an anodised, chromed or diamond cut finish should instead look to our Custom Wheel Cleaner solution, a product developed specifically for use on expensive aftermarket wheels, or those with thinner, more chemically sensitive coatings. Its carefully developed, acid free, alkaline formulation means that it will have no problem removing the iron deposits caused by repeated braking, yet won’t cause damage to the alloy itself. One feature of Adam’s Polishes that stood out is the odor, which was much stronger than the other wheel cleaners we tested. It smells very strongly of artificial cherry – not a terrible smell but something some consumers may find unpleasant.
A) In the right hands, yes, but be sure to read the label and safety data sheet before you decide. That being said, we really don’t know why you’d want to, not when Clean Wheels is so effective, affordable and simple to use. Clean Wheels has been proven to be every bit as effective as commercial cleaners yet comes in a ready to use form, meaning that you can leave diluting acid wheel cleaners to the professionals.
While the smell is certainly pronounced, we didn’t find it that unpleasant, and some reviewers even liked it. However, it does not smell like something you want to inhale, so be sure to wear a mask when using any chemicals, including Adam’s Polishes. Polishing your car is a great way to fade small scratches and imperfections. Find out how with our handy guide. Based on our testing, we believe Turtle Wax T-18 wheel cleaner is your best bet for removing any debris, but you should use Meguiar’s G180132 ultimate wheel cleaner for painted wheels and Chemical Guys Diablo Gel for chrome or polished metal. Does WD-40 clean alloy wheels? Most reviewers note how well Meguiar’s works, even without scrubbing. While we used a cleaning brush during our test, many reported that simply spraying and washing was enough to fully clean their wheels. Clean wheels are, in our opinion, the most important finisher to get your classic car looking smart and well looked after. No point cleaning it at all if you’re not going to get the wheels sparkling; it’s like cleaning the house and then not vacuuming the carpet.With a pH of 2.5, white vinegar is fairly acidic, which can be too aggressive on your clear coat. To tone it down, you need to mix with equal parts distilled water and put it in a spray bottle. Don’t spray directly onto the car. The acid is highly corrosive to glass, rubber, and plastic trim, so you don’t want any overspray. We find this is a harsh process and can leave pitting; therefore we now use the latest techniques which involve us removing all the paint and corrosion in an acid bath. This is carried out at our depot. Due to the strength of the acid used we cannot do it on the mobile service. You can have your wheels painted to the original colour or if you fancy a change we can mix any colour you like. If you have a specific colour you would like you can supply us with a paint code and we will match it. The steps for the acid stripping and powder coating process are as follows: You wouldn’t believe it, but one of the most effective solutions for hard water stains and mineral deposits is white vinegar.