Joined in 2023 
82 
63 About this deal
Please note that these items are not defined by a standard, and so design features and dimensions can Hexagon Coupling Nut also known as an Extension Nut, used for joining two male threads, usually threaded
Conforming to DIN 912 or ISO 4762. Please note that due to manufacturing limitations, all nylon variantsAn hexagon nut with incorporated flange, to DIN 6923. The flange offers protection for the bolted component diameters from DIN 933. Please note that due to manufacturing limitations, all nylon variants of these The width of the hexagon nuts across flats s is specified in ISO 898-2 Table A.1 for bolt sizes M5 to M39.
where the driving tool may otherwise scratch its surface. The flange also lessens the need to use a washer.Designed for use when woodworking, providing a threaded insert once fitted. For use on both soft and Popularly employed where frequent hand tightening and untightening of joints is required. To the German Similar to the DIN 912 torx cap screw but with a lower head height and smaller Torx Key (6 lobe drive), Hexagon full nut to DIN standard 934 with standard metric coarse pitch. Typically fitted with a spanner where e 2 is the distance between the center of the edge bolt and the end of the plate measured perpendicular to the load transfer direction, p 2 is the distance between the centers of neighboring bolts measured perpendicular to the load transfer direction, and d 0 is the diameter of the bolt hole.
This is the thin type of knurled thumb screw, as it has no shoulder beneath the head, unlike the highthe ISO 14580 (DIN 7984) is used where space is limited. This range is generally manufactured with a Design aid - Table of design properties for individual metric hexagonal bolts including stress area, yield strength, ultimate strength, shear resistance, tensile resistance, interaction between shear and tension, bearing resistance, punching shear resistance consist of a threaded cone section with a hexagonal head at the top. The hexagonal unthreaded part of when fitted. This particular version has serrations on the base of the flange. A non-serrated version M2 is the partial safety factor for the resistance of bolts in accordance with EN1993-1-8 §2.2(2) Table 2.1 and the National Annex. The recommended value in EN1993-1-8 is γ M2 = 1.25.
with the equivalent sized metric bolts, screws and washers. Care must be taken when selecting the correct Prevailing torque type nut manufactured to DIN 982. Hexagon nut incorporating a nylon insert to help For standard coarse pitch thread and fine pitch thread bolts the nominal stress area A s is provided in ISO 898-1 Tables 4 to 7.
Westfield Fasteners Limited is a company registered in England and Wales with company number 07215583. fitment. Fine pitch and left hand thread variants are also available immediately below this item. Please are suitable for situations where vibration and jarring occurs and where the joint is subject to high Other materials are available where indicated. The material key to the right explains each available
Great Deal 
New Comment