The front and rear position lamps must light up at the same time with the end-outline marker lamps where they are fitted. Lamps, reflectors and electrical equipment - Stop lamps - Presence, condition and operation - Added sentence 'On some vehicles with LED rear lamps, a proportion of the stop lamp LED's may extinguish when the rear fog lamp is illuminated. This is not to be regarded as a defect.' Generate content: And voila! The last step is generating the final article. Seems like magic, right? There’s a reason it’s called a wizard. Direction indicators and hazard warning lamps - 4.4.1. Presence, condition and operation - Sentence changed from 'Direction indicators and hazard warning lamps are not needed for vehicles that:' to 'Direction indicators and hazard warning lamps are not required on vehicles:' It must be noted that a position lamp must never replace a marker light. A separate lamp must be fitted instead.

that do not have front and rear position lamps, or have such lamps permanently disconnected, painted over or masked that are only used during daylight hours and not used at times of seriously reduced visibility. Appendix C: Seat belt fitment tables - Heading changed from 'All motor vehicles' to 'Look up tables' Daytime running lamps (DRLs) or headlamps may function as front position lamps. If the DRLs function as front position lamps, they may or may not dim when rear position lamps are switched on and may dim or turn off when headlamps are switched on. End-outline marker lampsSuspension - Suspension arms, rods, struts, sub-frames, anti-roll bars etc - Sentence added 'A missing bump stop rubber is not a reason for failure.' Buses first used before 1 October 1969 only need one headlamp. If 2 are fitted, neither the main beam or dipped beams need to be a matched pair. a circular lens marked with the figure 2 – it might also have an arrow showing the direction of dip It helps save time by automatically organizing your information into a cohesive outline. This is especially helpful for content creators who are resource constrained or have a lot of ground to cover. How to use Copy.ai’s blog outline generator in 4 steps Stop lamps - 4.3.3. Compliance with requirements - Sentence changed from 'Stop lamps are not needed for vehicles that:' to 'Stop lamps are not required on vehicles:'

Rear reflectors - 4.8.2. Compliance with requirements - Sentence changed from 'Rear reflectors are not needed on vehicles:' to 'Rear reflectors are not required on vehicles not fitted with front and rear position lamps, or have such lamps permanently disconnected, painted over or masked and are:'

Lamps, reflectors and electrical equipment - Stop lamps - Compliance with requirements - Applicable from 1 February 2021 - Defect (a) (i) changed from 'emitted colour, position or intensity not in accordance with the requirements' to 'position or intensity not in accordance with the requirements' Exhaust emissions - Gaseous emissions - Full catalyst test - Item 8 added 'If the vehicle fails the emissions test, a copy of the result print out must be given to the customer. The VTS must keep a readily retrievable record of the result for 3 months.' Additional stop lamps, over and above the obligatory requirements, must be tested. However, if you are not sure that they’re connected, you should give the benefit of the doubt. Headlamps - Compliance with requirements - Changed sentence from 'Existing halogen headlamp units should not be converted to be used with HID bulbs. If such a conversion has been done, you must fail the headlamp.' to 'Existing halogen headlamp units should not be converted to be used with high intensity discharge (HID) or light emitting diode (LED) bulbs. If such a conversion has been done, you must fail the headlamp.' Rear reflectors - 4.8.2. Compliance with requirements - New bullet points added after the sentence ''Rear reflectors are not required on vehicles not fitted with front and rear position lamps, or have such lamps permanently disconnected, painted over or masked and are:'